BRAVO PRO CHANGE LOG 09/12/2007 **Scroll to bottom for latest version 1.22.** Ver1.14 12/23/2004 1) Corrected carriage stall detection. a) Loop in LEXMOV routine did not have a restart for the LEX. 2) Terminated POR LED flash sequence when Tray Home error occurs during LEX POR. 3) Corrected Error recovery for disk out error in VER1.13 12/09/2004. 4) Added retry to ARM HOME. 5) Added retry to UNHOOK. 6) Added retry to carriage movements. Ver1.15 03/15/2005 1) Corrected problem with long moves to 1st print line. Ver1.16 09/01/2005 1) Added command: $a8 Move from Printer Recorder B.. 2) Fixed bug in LEOMKK. 3) Fixed startup problem when LEX POR is interrupted with a USB reset. 4) Add USB serial # to status output. Ver1.17 02/20/2006 1) Added command to set EESYSF for the function disable flag. Bit Position: Desc: 0 Disable Power flag. 1 Disable Ink out error. 2 Disable Cover flag. $1b, $04, $0f, xx, 00,00,00,ck 2) When cover is disabled the power button changes: a) Will toggle position between center and home. b) Hold power button for 3 seconds to power off. 3) Cartridge button press will cancel a PC initiated PEN change function. 4) Added hookup to the following commands: a) PIKQCK $9a. b) HOOVER $9b. c) PIKDSK $92. Ver1.18 04/13/2006 1) Fix for hunting at the picker drop off position. a) Found that the no check zone was < than the Picker drop off position. GstonePro.LOD Ver: 33 04/20/2006 1) Changed LEX firmware to give up after 6 tries on position, had bug in old system if the head jumped to fast would not stop retrying. Ver1.19 05/03/2006 1) Fixed TEST MODE lockup. a) UTL changes and TOGHED change. 2) Add check for MODE:0 from PGA and error if found. 3) Added retry on Printer and Recorders even if disk switch not hit. 4) OEM: Make system retry on lid closed. 5) OEM: Add command to turn off/on POWER LED. Ver1.20 06/15/2006 VER1.20 1) Change to go to cap position before a print. a) This insures that the head mantenance is performed before the print. This helps prevent the problems with light printing at begining of the print. Ver1.21 03/28/2007 1) Corrected cover status flag operation. 2) Made tray in out functions check the sensor before making move decision. 3) Added command to MOVE functions that does nothing. a) This is to clear the last command executed data. Ver1.22 09/12/2007 1) Made cover open flag work during all operations of the system.