LX400 Firmware Changes:			  07/16/2007

VER26 07/16/2007
1) Corrected bug in system that would cause the system to try to load paper when switching from through to reflective
	mode on paper sensor.
	a) System would go into an TOF paper out error and could not clear it or switch back to through mode.

VER25 02/07/2007
1) Changing ACK handling from PIC system.
	a) Added timeout delay on receiving 'Y' From PIC system. We had problem with some Pic board not programming
		, this should fix that problem.
2) Fixed problem with PAPER OUT calibration.
	a) Having problems with calibration if system detected paper in sensor even if it was not there.

VER24 01/17/2007
1) Add Fire Pulse Adder and a command to set it.
	a) Used to address issue with some PEN's printing light.
	b) Default is set to +1.
2) Changed Alignment print VO values by moving range up by two levels.
3) Corrected bug in Alignment code and adjusted scan variables.
	a) Fixes bad alignment scans.
4) Corrected feed problem.
	a) Was not feeding to next label at times.
5) Fixed system lock up after a continuous forms print.
6) Alignment print fixed.
	a) Problem found in VO level last scan alignment not correct.